Audi A3 (8V) – LED rear indicators in phase opposition (Coding)
Purpose: Allows you to configure the LED rear indicators in phase opposition. (The outer and inner indicators light up alternately, Pace Car Lights)
Attention!! There are, here, 2 lines of coding to be done. (A3 Phase 1 only)
Proceed:
1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to
the computer then connect the other end to the diagnostic socket of your vehicle.
2 – Switch on the ignition then launch the VCDS program.
Line 1:
3 – Click on “ Select ” then click on “ 09 – Central Electrics ”.
4 – Click on “ Security Access – 16 ” then enter the code “ 31347 ”
5 – Click on “ Adaptation – 10 ”.
6 – On this page, at the very top, there is a drop-down menu.
In this drop-down menu, choose “ Leuchte 16BLK SLB35BLK SL KC9-Lichtfunktion A 16 ”
7 – On this same page, there is a second drop-down menu but towards the bottom
of the page.
On the latter, choose “ Blinken Links Dunkelphase ” then validate. (Origin: Blinken Links Hellphase)
Line 2:
3 – Click on “ Select ” then click on “ 09 – Power Station ”.
4 – Click on “ Security Access – 16 ” then type the code “ 31347 ”
5 – Click on “ Adaptation – 10 ”.
6 – On this page, at the very top, there is a drop-down menu.
In this drop-down menu, choose “ Leuchte 17TFL R BLK SRB3TFL R BLK SR KC3-Lichtfunktion A 17 ”
7 – On this same page, there is a second drop-down menu but towards the bottom
of the page.
On the latter, choose “ Blinken Retchs Dunkelphase ” then validate. (Origin: Blinken Retchs Hellphase)