Audi A3 (8V) – Wiper angle in service mode position (Coding)
Purpose: Allows you to change the angle at which the wipers are located when they are in replacement mode.
Proceed:
1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to the computer then connect the other end to the diagnostic socket of your vehicle.
2 – Switch on the ignition then launch the VCDS program.
Line 1:
3 – Click on “ Select ” then click on “ 09- Central electrical unit ”.
4 – Click on “ Security Access – 16 ” then enter the code “ 31347 ”
5 – Click on “ Adaptation – 10 ”.
6 – On this page, at the very top, there is a drop-down menu.
In this drop-down menu, choose “ Service Position ”
7 – On this same page there is a second drop-down menu but towards the bottom
of the page.
On this last one, choose the desired angle value. By default: “ 170.49° ” then validate.