Audi A3 (8P) – Selective door unlocking (Coding)
Purpose : Allows you to configure selective door unlocking.
When unlocking the vehicle, only the driver’s door will be unlocked. To unlock all doors, press the unlock button on the remote control twice.
Proceed:
1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to the computer then connect the other end to the diagnostic socket of your vehicle.
2 – Switch on the ignition then launch the VCDS program.
Line 1:
3 – Click on “ Select ” then click on “ 46 – Comfort Module ”.
4 – Click on “ Adaptation – 10 ”
Channel 03
Set the value to 1
Line 2:
If the adaptation channel is not activated.
3 – Click on “ Select ” then click on “ 46 – Comfort Module ”.
4 – Click on “ Coding – 07 ” then Long Coding Wizard
Byte 0:
Bit 0: Check “Selective Central Locking (Single Door Opening)“