Audi A3 (8P) – Door unlock confirmation (Remote control) (Coding)

Audi A3 (8P) – Door unlock confirmation (Remote control) (Coding)

Purpose : Allows you to configure the door unlock confirmation when using the remote control.

Proceed:
1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to the computer then connect the other end to the diagnostic socket of your vehicle.

2 – Switch on the ignition then launch the VCDS program.

Line 1:

3 – Click on “  Select  ” then click on “  46 – Comfort Module ”.

4 – Click on “  Adaptation – 10 ” 

Channel 07

Set the value to 0 (no confirmation)
Set the value to 1 (confirmation with indicators)
Set the value to 2 (confirmation with Beep/Horn)
Set the value to 3 (confirmation with indicators + Beep/Horn)

Line 2:

If the adaptation channel is not activated.

3 – Click on “  Select  ” then click on “  46 – Comfort Module ”.

4 – Click on “  Coding – 07  ” then Long Coding WizardByte 10 : 

Bit 2 : Check “Unlocking Confirmation (Blink) via Remote Control”
Bit 3 : Check “Unlocking Confirmation (Horn) via Remote Control”