Audi A3 (8P) – Door lock confirmation (Remote control) (Coding)
Purpose : Allows you to set the door lock confirmation when using the remote control.
Proceed:
1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to the computer then connect the other end to the diagnostic socket of your vehicle.
2 – Switch on the ignition then launch the VCDS program.
Line 1:
3 – Click on “ Select ” then click on “ 46 – Comfort Module ”.
4 – Click on “ Adaptation – 10 ”
Channel 10
Set the value to 0 (no confirmation)
Set the value to 1 (confirmation with indicators)
Set the value to 2 (confirmation with Beep/Horn)
Set the value to 3 (confirmation with indicators + Beep/Horn)
Line 2:
If the adaptation channel is not activated.
3 – Click on “ Select ” then click on “ 46 – Comfort Module ”.
4 – Click on “ Coding – 07 ” then Long Coding Wizard
Byte 11 :
Bit 2 : Check “Locking Confirmation (Blink) via Remote Control”
Bit 3 : Check “Locking Confirmation (Horn) via Remote Control”
