Audi A3 (8P) – Door lock confirmation (key) (Coding)

Audi A3 (8P) – Door lock confirmation (key) (Coding)

Purpose : Allows you to configure the door locking confirmation when using the key.

Proceed:
1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to the computer then connect the other end to the diagnostic socket of your vehicle.

2 – Switch on the ignition then launch the VCDS program.

Line 1:

3 – Click on “  Select  ” then click on “  46 – Comfort Module ”.

4 – Click on “  Adaptation – 10 ” 

Channel 11

Set the value to 0 (no confirmation)
Set the value to 1 (confirmation with indicators)
Set the value to 2 (confirmation with Beep/Horn)
Set the value to 3 (confirmation with indicators + Beep/Horn)

Line 2:

If the adaptation channel is not activated.

3 – Click on “  Select  ” then click on “  46 – Comfort Module ”.

4 – Click on “  Coding – 07  ” then Long Coding Wizard

Byte 11 : 
Bit 0 : Check “Locking Confirmation (Blink) via Door Locks”
Bit 1 : Check “Locking Confirmation (Horn) via Door Locks”