Audi A1 (GB) – Remove seat belt alarm (Coding)
Purpose: Allows you to suppress the audible alarm and the warning light in the Virtual Cockpit when driving without a seat belt.
Proceed as follows:
1 – With the engine off and the ignition off, connect your official VAG-COM VCDS cable to the computer and then connect the other end to the diagnostic socket of your vehicle.
2 – Switch on the ignition and then launch the VCDS program.
Line 1:
3 – Click on “ Select ” and then click on “ 17 – Instruments ”.
4 – Click on “ Coding – 07 ” then “ Long Coding Wizard ”.
5 – Select byte 0 :
Bit 2-4 : Select “Seat Belt Warning inactive” from the drop-down list.
OR
4 – Click on “ Adaptation – 10 ”.
5 – Click on “ Security Access – 16 ” then type the code “ 20103 ” .
6 – On this page, at the very top, there is a drop-down menu.
In this drop-down menu, choose “Deactivate Seat belt warning” .
7 – On this same page, there is a second drop-down menu but towards the bottom
of the page.
On the latter, choose “ Yes ” then validate.
